How to use Drive Train Degreaser
For use only in open well ventilated areas. Shake can before use.
Step 1: Initially spray from a distance of 15cm to wet down the surface to be cleaned.
Step 2: Leave to soak for 20 seconds.
Step 3: After surfaces have been wetted, blast away contaminants by moving the aerosol closer and using prolonged bursts. Catch residue with an absorbent cloth.
Step 4: Watch the dirt run off, spray again until cassette, chain and mechs are completely free of dirt. After clean care: Relube with any Fenwicks chain lube.
Handy hints
May also be washed off with water.
As a solvent based degreaser Drive Train Degreaser should only be used to clean your cassette, chain, chain rings and mechs.